Hints and Advice

In order to assist your choice of towel rail, the following check points should help to avoid the specification of an unsuitable model.

  • Ensure the space you have is of adequate dimensions and that suitable services can be directed to the location.
  • Check you have sufficient room to accept the projection of the towel rail without impeding access or door opening etc.
  • Ensure the towel rail of your choice is suited to the circuit available. Never install an item containing Ferrous Metal (Steel) parts on an open circuit.
  • Never install a towel rail without providing for suitable isolation.
  • Consider the benefits of an electrical immersion heater for continued operation in the summer months. When utilised, one isolating valve should be turned off to prevent circulation through the system. Appropriate measures should also be taken to ensure the continued venting and filling of the product. On no account should the electric option be operated in tandem with the central heating.
  • All Vogue UK products must be installed in accordance with BS5449, BS7593 and BS7671 or with those enforced by the appropriate regulatory bodies for the country or region in which the unit will be located to avoid invalidation of the guarantee.

HEATING SYSTEMS

Typically, there are two types of water circuit in a domestic residence, as follows:

heating only (closed circuit) Indirect or Closed Hot Water circuit

heating only  Direct or Open Hot Water circuit

HEATING OPTIONS

heating only Heating Only (HO) - Suitable for ALL circuits

heating only (closed circuit) Heating Only (HO) - Suitable for indirect (closed) circuits only

electric only Electric Only (EO)

dual energy Heating & Electric (HE)

HEATING ELEMENTS

Standard element - IP55

Suitable for installation into Zones 1 and 2 of the bathroom for non high pressure water jet applications.Suitable for installation into Zones 1 and 2 of the bathroom for non high pressure water jet applications.Manufactured in accordance with: EN60335-1 / BS EN ISO 9001

BATHROOM ZONES

The diagrams and information below are a guide to Bathroom Zones as referred to in IP ratings of the Heating ElementsThe diagrams and information below are a guide to Bathroom Zones as referred to in IP ratings of the Heating Elementssection. Please refer to the latest edition of BS7871 to ensure conformity.

TECHNICAL SPECIFICATIONS

All heat outputs are shown at 50ºCΔt, in compliance with BSEN442 - Specification for Radiators and Convectors.To convert to 60ºCΔt, multiply heat output by conversion factor 1.268 (approximate figure). All measurements given are nominal dimensions only (mm), and are not binding. 

Manufactured from hot brass stamped fittings and high quality brass tube complying to BS2871.

Some models manufactured from high grade CR steel tubing and/or containing steel components suitable for closed/indirect circuits only. All rails are pressure tested to 100p.s.i (6.9 bar) air immersed in water.

All models are fitted with 2 x 1/2" BSP F.I. connections. Alternative M.I. or compression fitting is available on request. 3/4"BSP connections available at extra cost on some models. A manual bleed air vent is fitted to all hot water/dual fuel models. Auto air vents available on request at additional cost.

AWARDS

Awards front page

© VOGUE (UK) LTD, 2018.      Privacy Policy |  Terms Of UseAccessibility Statement

Website Design by Make it Seen Media

Menu